DDJ-400 controls explained
Every button, knob and fader on the Pioneer DDJ-400, and what it's for. Tap a control on the drawing, or scroll down for the full list.
Support for the DDJ-400 is new. If anything doesn't respond, tell us at hello@nosyncclub.com.
Tap any control on the drawing to see what it does.
Every control on the DDJ-400
The decks
- IN/4BEATSHIFT: IN ADJUST
- Marks where a loop starts; press loop out on a later beat to repeat everything in between.
- OUTSHIFT: OUT ADJUST
- Marks where a loop ends, so the part since loop in repeats until you leave it.
- RELOOP/EXITSHIFT: ACTIVE LOOP
- Leaves a loop so the track plays on, or starts an instant 4-beat loop when none is playing.
- CUE/LOOP CALL ◀
- Halves a playing loop. With no loop on, it steps back through the cues saved in the track.
- CUE/LOOP CALL ▶
- Doubles a playing loop. With no loop on, it steps forward through the cues saved in the track.
- BEAT SYNCSHIFT: TEMPO RANGE
- Matches this track's tempo to the other deck's in one press, so you can mix before you can beatmatch by ear.
- Jog wheel, outer edge
- Turn the outer edge of the jog wheel to nudge a playing track slightly ahead or behind, to line its beats up.
- Jog wheel, top
- Touch and turn the top of the jog wheel to scratch, or to find your place in a paused track.
- SHIFT
- Hold it to give other buttons their second job, the one printed underneath them.
- CUE
- Jumps back to the cue point, the place you've marked to start from, and plays from it for as long as you hold it.
- PLAY
- Starts the track, and pauses it where it is when pressed again.
- Pad mode buttons
- Picks what the eight pads below do, such as hot cues, beat jumps or samples.
- HOT CUE · SHIFT: KEYBOARD
- BEAT LOOP · SHIFT: PAD FX1
- BEAT JUMP · SHIFT: PAD FX2
- SAMPLER · SHIFT: KEY SHIFT
- Performance pads
- Each pad does what the current pad mode says: jump to a hot cue, start a loop, play a sample and more.
- TEMPO
- Speeds the track up or slows it down, so its beats can match the other track's.
The mixer
- TRIM
- Sets how loud the track comes into the mixer, so every track starts at the same level before the fader.
- HI
- Turns the treble up or down: hi-hats, cymbals and the shine on vocals.
- MID
- Turns the middle up or down: vocals, synths and snares.
- LOW
- Turns the bass up or down: the kick and bassline, the part two tracks shouldn't share at once.
- FILTER
- Turn it left to cut the highs or right to cut the lows: a quick way to bring a track in or out smoothly.
- Channel faders
- Sets how much of this channel the room hears; up is louder.
- CROSSFADER
- Slides the room's sound between the left and right channels.
- MASTER LEVEL
- Sets the overall volume of the mix going to the speakers.
Headphones
- MIXING
- Blends your headphones between the track you're cueing and what the room hears.
- LEVEL
- Sets how loud your headphones are.
- Channel CUE
- Sends this channel to your headphones, so you can get the next track ready without the room hearing it.
- MASTER CUE
- Puts what the room hears in your headphones too, to check the whole mix.
The browser
- LOADSHIFT: RELATED TRACKS
- Puts the track chosen in your library on this deck.
- Browse knob
- Turn it to scroll through your tracks in the library.
- Browse knob, pressed
- Press the browse knob to open or close a folder in your library.
Effects
- 1/2/MASTER
- Picks which channel the effect is on.
- FX SELECT
- Picks which effect to use, such as echo or reverb.
- BEAT ◀
- Makes the effect follow shorter note lengths, like echoes every half beat instead of every beat.
- BEAT ▶
- Makes the effect follow longer note lengths, like echoes every two beats instead of every beat.
- LEVEL/DEPTH
- Sets how strong the effect is, from barely there to taking over the sound.
- ON/OFFSHIFT: RELEASE FX
- Turns the effect on and off.
What you can learn on the DDJ-400
All 20 lessons work on the DDJ-400.
Getting set up
- Your controller
Stage 01: Beatmatching
- Play a track
- Match the tempo
- Line up the beats
- Your first blend
- Beatmatch by ear
Stage 02: Mixing on the phrase
- Count the bars
- Mix on the phrase
- Levels and meters
- EQ the blend
- Filter the mix
Stage 03: Performance tools
- Hot cues
- Loops
- Beat jump
- Echo out
Stage 04: Building a set
- Mixing in key
- Choose the next track
- Ride the tempo
- Half-time
- Record a mix
Guides for the DDJ-400
Learn it on your DDJ-400
Plug it in, open Chrome or Edge, and the first lesson tours your own controller. No card needed.