Founding price: £5 a month instead of £7.50 · until 30 November →

Guide

How to use EQ when you mix

Two tracks playing at once is twice the sound in the same space. EQ is how you make room. Each channel's three knobs, HI, MID and LOW, turn one slice of the sound up or down, so you can share the space out instead of piling it up.

What each knob does

  • LOW: the kick and the bassline. It's the part two tracks fight over most.
  • MID: vocals, synths, snares, most of the melody.
  • HI: hi-hats, cymbals, the air on top.
  • In the middle, a knob leaves the track as it was made. Turn it left to cut that slice, or right to boost it.

The bass swap

Two basslines at once sound muddy, and two kicks a hair apart sound like a gallop. So only one track gets the low end at a time.

  1. Bring the new track in with its LOW turned right down.
  2. On the 1 of a phrase, in one move, turn the old track's LOW down and the new track's LOW back to the middle.
  3. Then bring the old track's fader down.

It's the single most useful EQ move, and it's what most house and techno blends are built on.

Cut, don't boost

  • If something sounds too loud, turn the other track's slice down rather than turning this one up.
  • Boosting adds level, and level you didn't plan for pushes the mix into the red.
  • Most of the time the knobs sit in the middle or to the left of it.

Making room for a vocal

  • When both tracks have vocals or busy synths, turn the MID down a little on the track that matters less.
  • You don't need a full cut. Just enough that the words come through.

Smooth moves, not sudden ones

Turning a knob slowly over 8 or 16 bars sounds like a blend. The same turn in a single beat sounds like a mistake, unless you mean it, as with the bass swap on the 1.

Practise it

No Sync Club's EQ lesson runs a full bass-swap blend on your own controller and checks when you made each move.

Practise this

EQ the blend

Lesson 2.4 · 12 min · on your own controller · Headliner